Filter
Top Products
5.5.1.4 Is the Head angle correct?
This section describes either the head angle condition is correct or not. Refer to Section 4.1.3 for the acrual
adjustment.
[Step 1] Perform the head angle adjustment. (Refer to Section 4.1.3.)
Note: If the head angle condition is wrong, white or color banding problem will be appeared on the
graphic pattern.
5.5.1.5 Initial charge operation
Since the status, whether the initial charge operation has been performed or not, is stored in the EEPROM,
you have to clear this with the adjustment program to perform the initial charge operation again on the same
printer.
[Step 1] Execute the adjustment program “CLR200.EXE” and select “EEPROM Data Manipulation”.
[Step 2] Choose “INITIAL-CHARGE FLAG RESET” from the sub menu.
[Step 3] Install new printhead and new ink cartridge on the printer. Then turn the printer on to
start the initial-charge operation.
5.5.1.6 Replace to new ink cartridge
It is necessary to replace the print head unit if you can not recover alogged nozzle by performing the initial
ink charge, CL operation and replacing the new ink cartridge.
If you replace to new ink cartridge, do not re-use a removed ink cartridge again.
Epson Stylus Color 200 /Epson Stylus 200 Troubleshooting
Rev. A 5-11