Filter
Top Products
Running
the
self test
1.
Make sure the printer is turned off.
2.
While holding down the Font button, turn on the printer. It
loads a sheet of paper automatically from the paper feeder
and begins the self test. It prints on the first and last lines of
page
1
to measure the page length. Then the printer prints
characters in each font on page
2.
Here is part of a typical self test:
Courier
!“#$%&‘(
)*+,-.
/0123456789:;<=??@AB
!“#$%&’
()*+,-.
/0123456789:;<=>?@ABC
“#I$%&’
()*+,,-.
/0123456789:;<=>?@ABCD
#$%a’()*+,-.
/0123456789:;<=>?@ABCDE
$%&I()*+,-.
/0123456789:;<=>?@ABCDEF
%a’()*+,-.
/0123456789:;<=>?@ABCDEFG
&‘()*+,-.
/0123456789:;<=>?@ABCDEFGH
Roman T
I()*+,-./0123456789:;<=>?@ABCDEFGHIJKLMNOF’QRS
O*+,-./0123456789:;<=>?@ABCDEFGHIJKLMNOF’QRS’I
I*+,-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTl
3.
The self test continues
until
the paper in the paper feeder
runs out or you press the
Pause button. To stop the test,
press the
Pause button. To resume the test, press the
Pause button again.
4.
To end the self test, press the Pause button to stop printing
and then press the
Load/Eject button to eject the paper.
5.
Turn off the printer.
Setting Up Your Printer
1-15