Filter
Top Products
Setting Up the PriorityFax
Rear
Front
hole
Place the output tray in front of you and insert each of the
two wire paper holders into the holes at the edge of the
output tray, as shown below.
To attach the output tray to the output tray base, locate the
holes on either side of the output tray base. Then insert the
pegs on either side of the output tray into these holes, as
shown below.
Note
This tray can used in a horizontal position instead of
the vertical position shown on the next page. If you plan to
use the tray in the horizontal position, insert the pegs into
the rear slots instead of the front holes. Then push the
output tray as far back as it will go.
1-7