Filter
Top Products
Contents
Extron • System 4
xi
Switcher Series • User’s Manual
System 4
xi
Switcher Series
Getting Started..........
tt
Step 1
uu
If the System 4xi is already configured for your model of projector, go to
Step 4
. If it is not set
up correctly, it will be necessary to change switch settings on the System 4xi ’s Main
Controller Board. Continue with
Step 2
below to verify the correct configuration.
tt
Step 2
uu
Apply power to the System 4xi. Use the front panel to display the Information Menu (Menu 8).
If the configuration is correct, go to
Step 4
. If it is not correct, continue with
Step 3
.
tt
Step 3
uu
Go to the procedure on page 2-3 of the
System 4
xi
User’s Manual
to remove the System 4xi
cover. Then go to page 2-4 for instructions on configuring the Main Controller board. The
following table and diagram are to be used only as examples of a typical configuration. Please
consult either the label inside the System 4xi top cover or the
System 4
xi
Projector
Communications Kit
instructions for the correct configuration settings. Continue with
Step 4
below when your configuration is correct.
Config Projector SW1: 1-2-3-4 SW2 SW3 SW4 SW5 SW6 Prj Cable Comm
as Adapter
✔ Your Model off-on-off-on 0 1 0 5 0 J15 26-467-01
tt
Step 4
uu
Double-check your work and be sure the System 4xi cover is back on securely.
tt
Step 5
uu
Please refer to the appropriate connection diagram for your projector (see your
System 4
xi
Projector Communications Kit
instructions). Using the appropriate Communications Adapter
included in your Communications Kit, connect the Comm extension cable from the PJ Comm
port of the System 4xi to the Comm Adapter. Secure the Comm Adapter to the appropriate
projector port.
tt
Step 6
uu
Connect the RGBS/HV cable from the System 4xi output BNC connectors to the projector’s
matching RGBS/HV input connectors. Verify that all your connections are correct. If in
doubt, please refer to the specific installation instructions which were included in your
Communications Kit.
SW1
SW2
SW6
SW3
SW5
J15
3
4
1
2
SW4