Filter
Top Products
Extron • Matrix 3200/6400 Series • User’s Manual
Chapter 4 • Programmer’s Guide
4-7
ADVANCED INSTRUCTION SET AND SIMPLE INSTRUCTION SET COMMANDS (PAGE 2 OF 3)
VIEW COMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Virtual Output MUTES VM
1
•
2
• • • • •
64
Mut
Notes:
1. Start output is always
Ø
1 for Room PRESET, because room has max. of 16 outputs assigned.
2. All “VI” values in responses are 2 numeric characters (i.e. 12 or
Ø
3) or “na” indicating non-existant
virtual outputs
3. In “VA” View, any outputs that do not follow show as “- -“ in response
4. SO = “Start-Output” parameter in “Global Preset commands”.
5. Rvo - Rvo.... = Set of Virtual Outputs assigned to specified “room” (up to 16 total).
RGB DELAY COMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Read RGB Delay (for 1 ch.)
D Out •Dly
Set RGB Delay (for 1 ch.) d * Out •Dly
Note: Where = delay in 1/2 second increments (i.e.
Ø
=
Ø
sec, 1
Ø
= 5.
Ø
sec)
DIRECT WRITE OF
GLOBAL PRESETS COMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Start Write Mode
P Write Preset Ready
End Write Mode p End Write Preset
Example P32 Write Preset 32 Ready
1*1!
1*2&
1*3%
:
:
1*64$
p End Write Preset 32
Notes:
1. Any non-output switching or invalid command between the Start and End commands will be ignored.
2. If there is no activity for 5 seconds while in write mode, then error E17 occurs.
3. No front panel switching (Actual Switching) is allowed during the Start and End commands.
4. If an End command
p command is issued with no Start command, then error E10 occurs.
QUICK RECALL OF
GLOBAL PRESETS COMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Quick Recall Preset
. Rpr
Notes:
1. If the Quick Recall Preset (
.) command is issued without an active write, then error E10 occurs.
2. Complete backplane switch within 60mSeconds (apprx.) after receipt of the command.
3. Recall must take place 100mSeconds after End Write Mode command (
p ).
4. Quick recall command only recalls last entered direct write preset.
SET NAMES COMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Read Global preset name
NG
Write Global preset name nG , NamG
Read Room preset name NP *
Write Room preset name nP * , NamP
Read Room Name NR
Write Room Name nR , NamR
Read Virtual Input Name NI
Write Virtual Input Name nI , NamI
Read Virtual Output Name NO
Write Virtual Output Name nO , NamO
ADVANCED INSTRUCTION SET AND SIMPLE INSTRUCTION SET COMMANDS (PAGE 3 OF 3)