Filter
Top Products
Extron • Matrix 3200/6400 Series • User’s Manual
Chapter 4 • Programmer’s Guide
4-8
ZAP CONFIGURATION COMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Zap All Global presets & names
zG ZapG
Zap individual Global zT ZapT
Zap All Room presets & names zP ZapP
Zap individual Room Preset zT * ZapT
Zap All RGB Delay to Ø sec. zD ZapD
Zap all Audio Gains to Ø dB. zA ZapA
UnMute RGB/Audio (All Mutes) zZ ZapZ
Factory Master Reset zXXX ZapX
ERROR CODES
If the switcher receives a command that is invalid or contains invalid parameters, it will return an Error Code response.
The error code response has the format “Exx”. Following is a list of possible error code responses.
Description of Error code
E
Ø
1 Invalid input channel number (too large)
E
Ø
5 Device is off
E1
Ø
Invalid command
E11
Invalid preset number (too large)
E12
Invalid output number (too large)
E13 Value too large (Gain)
E14
Command not available for matrix configuration
E17
Timeout
E2
Ø
Invalid BME number
E21 Invalid Room number
E22
Busy
E23
Checksum error
SWITCHER GENERATED UNSOLICITED RESPONSES
When a local event takes place, such as a Front Panel operation, the switcher responds by sending an unsolicited
response (RECONFIGxx) to the Host. Use the 2 digit code xx to locate a description of the event below.
RECONFIG
ØØ
= Audio level change
RECONFIG
Ø
2 = Room#1 or room#1’s preset name change
RECONFIG
Ø
3 = Room#2 or room#2’s preset name change
RECONFIG
Ø
4 = Room#3 or room#3’s preset name change
RECONFIG
Ø
5 = Room#4 or room#4’s preset name change
RECONFIG
Ø
6 = Room#5 or room#5’s preset name change
RECONFIG
Ø
7 = Room#6 or room#6’s preset name change
RECONFIG
Ø
8 = Room#7 or room#7’s preset name change
RECONFIG
Ø
9 = Room#8 or room#8’s preset name change
RECONFIG1
Ø
= Room#9 or room#9’s preset name change
RECONFIG11 = Room#1
Ø
or room#1
Ø
’s preset name change
RECONFIG12 = Name change for global preset #1-16
RECONFIG13 = Name change for global preset #17-32
RECONFIG14 = Current connection change
RECONFIG17 = Name change for virtual input #1-16
RECONFIG18 = Name change for virtual input #17-32
RECONFIG19 = Name change for virtual input #33-48
RECONFIG2
Ø
= Name change for virtual input #49-64
RECONFIG21 = Name change for virtual output #1-16
RECONFIG22 = Name change for virtual output #17-32
RECONFIG23 = Name change for virtual output #33-48
RECONFIG24 = Name change for virtual output #49-64