Filter
Top Products
7DXP DVI Pro and DXP HDMI Series • Setup
b
Input connectors —
• DVI Pro series: Connect DVI-D source devices to these female
29-pin DVI-I input connectors. Only single-link DVI-D signals
are supported.
• HDMI series: Connect HDMI source devices to these female
19-pin type A HDMI input connectors.
LockIt™ cable lacing brackets, one for each HDMI input and
output connector, are provided with the DXP HDMI. These
brackets can be used to secure the HDMI cables to the DXP
connectors to reduce stress on the HDMI connectors and
prevent signal loss due to loose cable connections.
To securely fasten an HDMI cable to the DXP using LockIt
brackets:
1. Plug the HDMI cable into the panel connection.
3
3
1
2
4
5
Figure 5. Installing the LockIt Lacing Bracket
2. Loosen the HDMI connection mounting screw from the
panel enough to allow the LockIt lacing bracket to be
placed over it. The screw does not have to be removed.
3. Place the LockIt lacing bracket on the screw and against
the HDMI connector, then tighten the screw to secure the
bracket.
CAUTION: Do not overtighten the HDMI connector
mounting screw. The shield to which it fastens is
very thin and can easily be stripped.
4. Loosely place the included tie wrap around the HDMI
connector and the LockIt lacing bracket as shown.
5. While holding the connector securely against the lacing
bracket, use pliers or similar tools to tighten the tie wrap,
then remove any excess length.