Filter
Top Products
DXP DVI Pro and DXP HDMI Series • Remote Control 21
Remote Control
This section describes selected SIS commands that pertain to system
setup. It also contains instructions for obtaining, installing, and
starting the Matrix Switchers Control Program and for accessing the
DXP HTML pages. The following topics are discussed:
• Establishing a Network (Ethernet) Connection
• SIS Commands
• Installing and Starting the Matrix Switchers Control Program
• Accessing the HTML Pages
Establishing a Network (Ethernet) Connection
You can send SIS commands over an Ethernet link (rear panel RJ-45
LAN port) or a serial connection (front panel Config port or rear panel
Remote RS232/RS422 port). The network connection procedure is
described below; for information about the serial connection, see the
DXP DVI Pro and DXP HDMI Series User Guide.
Establish a network connection as follows:
1. Open a TCP socket to port 23 using the switcher IP address.
NOTE: The factory default IP address is 192.168.254.254.
The switcher responds with a message consisting of the copyright
date, the name of the product, firmware version, part number,
and the current date and time.
Example (with an Internet connection):
(c) Copyright 20nn, Extron Electronics DXP DVI-HDMI,
Vn.nn, 60-nnnn-01
]
Ddd, DD Mmm YYYY HH:MM:SS
]
NOTES: • If the switcher is not password-protected, the device is now
ready to accept SIS commands.
• If the switcher is password-protected, a password prompt
appears.
2. If the switcher is password-protected, enter the appropriate
password.
3. If the password is accepted, the switcher responds with Login
User or Login Administrator.
4. If the password is not accepted, the Password prompt reappears.