Filter
Top Products
9DXP DVI Pro and DXP HDMI Series • Setup
The cable you use depends on your network speed. The switcher
supports both 10 Mbps (10Base-T — Ethernet) and 100 Mbps
(100Base-T — Fast Ethernet), half-duplex and full-duplex, Ethernet
connections.
• 10Base-T Ethernet requires CAT 3 or higher UTP or STP cable.
• 100Base-T Fast Ethernet requires CAT 5e or higher UTP or STP
cable.
Terminate the Ethernet cable as required:
• Network connection — Wire as a patch (straight-through)
cable.
• Computer or control system connection — Wire as a
crossover cable.
NOTE: The factory default IP address is 192.168.254.254.
e
Reset LED — When the unit is being reset, this LED blinks the
appropriate number of times to indicate the level of reset that has
been performed.
f
Reset button — This recessed button initiates four levels (modes)
of reset. Use a pointed object such as a small Phillips screwdriver
or a stylus to press and hold the Reset button while the switcher is
running or being powered up.
• Hard reset (mode 1) — Hold the Reset button while powering
up the switcher to restore the DXP to the default factory
conditions. This reset restores the factory-installed firmware.
NOTE: This type of reset does not clear the current
configuration.
• Events reset (mode 3) — Press and hold the Reset button
for 3 seconds, then release and press it again momentarily to
toggle events monitoring on and off.
• IP settings reset (mode 4) — Press and hold the Reset
button for 6 seconds, then release it and press it again
momentarily to reset the switcher IP functions.
NOTE: IP settings reset does not replace any user-installed
firmware.
• Absolute reset (mode 5) — Press and hold the Reset button
for 9 seconds, then release it and press it again momentarily to
restore the switcher to the default factory conditions.
For more details on these reset modes, see the DXP DVI Pro and
DXP HDMI User Guide, available on the provided Extron Product
Software DVD or the Extron website at www.extron.com.