Filter
Top Products
DVS 510 Series • Remote Configuration and Control 63
Command
ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Presets (continued)
Input Presets
Recall input preset
2 * X2^ .
2 Rpr X2^ ] Recall input preset X2^.
Save input preset
2 * X2^ , 2 Spr X2^ ]
Save the parameters of the current input
to preset X2^ (for saved parameters, see
“Input presets” under “Symbol
Definitions for DVS 510 Series SIS
Commands”).
Input Preset Name
Write preset name
E X2^ , X1$ NP } Nmp X2^ , X1$ ]
Set name of preset X2^ to X1$. The
command character is a comma. Presets
can have up to 16 characters.
NOTE: The following characters are invalid in input preset names:
~ @ =
`
[] {} <> ’ ‘ “ ” ; (semicolon) : (colon) | / \ ? and space.
View preset name
E X2^ NP } X1$ ]
View the name of input preset X2^.
NOTE: To clear an input preset name, enter one space character for X1$.
Auto Memories
Enable
E 1 AMEM } Amem 1 ]
Enable auto memories to automatically
recall the previous settings for the
incoming signal (default).
Disable
E 0 AMEM } Amem 0 ]
Disable auto memories. Input presets
must be manually recalled to configure
the input.
View setting
E AMEM } X1) ]
View the status of auto memories.
Advanced Configuration
Test Pattern
Set test pattern
E X2) TEST } Test X2) ] Select test pattern X2).
View test pattern
E TEST } X2) ]
View the current test pattern.
Freeze
Set freeze
1 F
Frz 1 ]
Freeze the selected input.
Set freeze
0 F
Frz 0 ]
Unfreeze the selected input.
View
F
X1) ]
Show the freeze status (1= on, 0= off).
RGB Delay Time
Set RGB delay
E X3& VDLY } Vdly X3& ]
Set the time the DVS will delay displaying
the new input to X3&.
View setting
E VDLY } X3& ]
View the RGB delay setting.
NOTE: X1) = Auto memories or freeze status 0 = disabled, 1 = enabled
X1$ = Input preset name Up to 16 characters; no special characters
X2) = Test pattern 0 through 13 (see “Test pattern” under “Symbol Definitions for
DVS 510 Series SIS Commands” for the available test patterns).
X2^ = Input preset number 1 through 128
X3& = RGB delay amount 0 through 50 in 0.1-second increments. Default is 05 (0.5 seconds).