Extron electronic IPI 200 Switch User Manual


  Open as PDF
of 86
 
B-9
IPI 100 and IPI 200 Series • SIS Programming and Control
Command ASCII (Tenet
(host to intercom
URL Encoded
(host to intercom
Response
(intercom to host
Additiona Description
Firmware version, part number & information requests
N
In a query response, an asterisk (*) after the version number indicates the version that is currently used.
A question mark (? or ?.??) indicates that the factory default firmware is the only firmware loaded in the IPI.
A carat (^) indicates the version of firmware that should be running, but, since a mode 1 reset was performed, the factory default
firmware version is loaded and running instead.
An exclamation point (!) indicates that the firmware is corrupted.
Query
firmware
version
number
Qor1Q Qor1Q
X1! c
orVer01*
X1! ]
ShowtheIPI’srmwareversion
(
X1!
) to two decimal places. This
query yields the number of the
currently running version of the
user‑updatablermware
Example:
1Q 1Q
1.01
]
orVer01*1.01
Queryverbose
firmware
version
information
0Q 0Q
X1! X1! X1! ]
responses to
commands
2Q•3Q•4Q
]
X1!
=Version(typicallylistedto
two decimal places, e.g., x.xx)
Showsbootstrap,factory‑installed,
and current versions of firmware.
Example:
0Q 0Q
1.03•1.00*(1.18‑IPI201/IPI204‑Thu,20Jan200509:41:47
GMT)•1.01*(1.31‑IPI201/IPI204‑Tue,14Jun200500:54:58
GMT)
]
Query
bootstrap
firmware
version
2Q 2Q
X1! ]
orVer02*
X1! ]
Thebootstraprmwareisnotuser‑
replaceable, but you may need this
information during troubleshooting.
Example:
2Q 2Q
1.03
]
Queryfactory
firmware
version
3Q 3Q
X1! ]
orVer03*
X1! ]
X1!
= (kernel version–model
description–date time of upload)
Factory‑installedrmwareis
different from the bootstrap
rmware,butitisalsonotuser‑
replaceable. This firmware was
installed at the factory; it is the
version the controller reverts to after
a mode 1 reset (see chpt. 2).
Example:
3Q 3Q
1.00*(1.18‑IPI201/IPI204‑Thu,20Jan200509:41:47GMT)
]
Query
updated
firmware
version
4Q 4Q
X1!]
orVer04*
X1!]
X1!
= (kernel version–model
description–date time of upload)
Use this command to find out which
version of the firmware, if any, was
uploaded into the controller after it
left the factory
Example:
4Q 4Q
1.00*(1.64‑IPI201/IPI204‑Mon,28Feb200523:16:55GMT)
]
QueryFPGA
version
32Q 32Q
X1! ]
Showtheeld‑programmablegate
array (FPGA) firmware version to
two decimal places (x.xx).
Request the
IPI’spart
number
N N
60‑809‑0n
]
or
60‑810‑0n
]
or
Pno60‑809‑1n
]
or
Pno60‑810‑1n
]
SeepageA‑7for200Seriespart
numbers.
 previous next