Filter
Top Products
FortiBridge Version 3.0 Administration Guide
28 09-30000-0163-20061109
Completing the basic FortiBridge configuration Setting up FortiBridge units
Changing DNS server IP addresses
Change the FortiBridge DNS server IP addresses to the IP addresses of your
DNS servers. The correct DNS server configuration is required for alert email.
To change DNS server IP addresses
1 Log in to the CLI.
2 Change the primary and secondary DNS server IP addresses. Enter:
config system dns
set primary <address_ipv4>
set secondary <address_ipv4>
end
For example:
config system dns
set primary 192.168.30.23
set secondary 192.168.30.24
end
Adding static routes
Add static routes if you need to route packets from the FortiBridge unit through a
router to another network. For example, if alert email sends email messages from
the internal network to an email server on the Internet, you should add a route to
the Internet.
To add static routes
1 Log in to the CLI.
2 Add the default route. Enter:
config system route
edit <sequence_integer>
set gateway
<gateway-address_ipv4>
end
For example:
config system route
edit 1
set gateway 192.168.20.1
end
3 If required for your network configuration, add a static route. Enter:
config system route
edit <sequence_integer>
set gateway <gateway-address_ipv4>
set dst <destination-address_ipv4mask>
end
For example:
config system route
edit 2
set gateway 192.168.20.3
set dst 192.168.22.0 255.255.255.0
end