Filter
Top Products
FortiBridge Version 3.0 Administration Guide
66 09-30000-0163-20061109
system global config CLI commands
system global
Use this command to configure global settings that affect various FortiBridge systems and
configurations.
Command syntax pattern
config system global
set <keyword> <variable>
end
config system global
unset <keyword>
end
get system global
show system global
Keywords and variables Description Default
admintimeout
<minutes_integer>
Set the administrator idle timeout to control the
amount of inactive time before the administrator must
log in again. The maximum admintimeout is 480
minutes (8 hours). To improve security keep the idle
timeout at the default value.
5
dst {disable | enable} Enable or disable daylight saving time.
If you enable daylight saving time, the FortiBridge unit
adjusts the system time when the time zone changes
to daylight saving time and back to standard time.
disable
heartbeat {disable |
enable }
For future use. disable
hostname <name_str> Type a name for this FortiBridge unit. FortiBridge model
name.
interface-speed {100full
| 100half | 10full |
10half | auto }
This command is only available for the FBG-1000.
Set the network interface speed or allow each
interface to auto-sense the correct speed. Set to
auto, each FortiBridge network interface will
autosense the correct speed and adjust accordingly. If
the interface-speed command is used to specify a
speed, all FortiBridge interfaces are locked to the
selected speed.
Although the FortiBridge supports 10/100/1000mbps
speeds when set to auto, 1000half and 1000full are
not available for manual selection.
Some early units will return an Not supported by this
hardware error when this command is invoked. This is
normal as hardware support for interface-speed
was only added in later units.
auto
ntpserver {<name_str> |
<address_ipv4>}
Enter the domain name or IP address of a Network
Time Protocol (NTP) server.
132.246.168.148
ntpsync {disable |
enable}
Enable or disable automatically updating the system
date and time by connecting to a Network Time
Protocol (NTP) server. For more information about
NTP and to find the IP address of an NTP server that
you can use, see http://www.ntp.org.
disable