Filter
Top Products
config CLI commands probe probe_list {ping | http | ftp | pop3 | smtp | imap}
FortiBridge Version 3.0 Administration Guide
09-30000-0163-20061109 55
probe probe_list {ping | http | ftp | pop3 | smtp | imap}
Use this command to configure probes for ping, HTTP, FTP, POP3, SMTP, and IMAP traffic. Probes
monitor different types of traffic. For each protocol you configure the time interval between probes
(interval) and how many lost probes are required to register a failure (threshold). You can also enable
each probe and in all cases except ping you can specify the port used by the probe.
Command syntax pattern
config probe probe_list {ping | http | ftp | pop3 | smtp | imap}
set <keyword>
end
config probe probe_list {ping | http | ftp | pop3 | smtp | imap}
unset <keyword>
end
get probe probe_list {ping | http | ftp | pop3 | smtp | imap}
show probe probe_list {ping | http | ftp | pop3 | smtp | imap}
Example
Use the following command to enable HTTP probes and change the HTTP failure threshold to 5 and
the probe interval to 3.
config probe probe_list http
set status enable
set failure_threshold 5
set probe_interval 3
end
This example shows how to display the settings for the probe probe_list command.
get probe probe_list
This example shows how to display the settings for the http probe.
get probe probe_list http
This example shows how to display the configuration for the probe probe_list command.
show probe probe_list
Related Commands
• probe setting
Keywords and variables Description Default
failure_threshold
<threshold_integer>
The number of probe packets that are lost before the
FortiBridge unit determines that the FortiGate unit has failed.
3
probe_interval
<probe_integer>
The number of seconds between probe packets. 1
status {disable | enable} Enable or disable sending probe packets for the current
probe protocol
disable
test_port
<port-number_integer>
The port number on which the probe sends packets for a
give protocol.
ping (none)
http 80
ftp 21
pop3 110
smtp 25
imap 143