Filter
Top Products
52
3
Connecting Cables
This chapter explains points to note when connecting cables.
CAUTION
For details on how to connect the cables, refer to "SilkWorm 4016 Hardware Reference Manual" and
"SilkWorm 4016 QuickStart Guide".
Connect the cable to the FC Network Blade installed in the BX600 S3 chassis, or the
port used by the FC Network Blade.
Each cable connector has a protrusion which determines the inserting direction of the
connector. When connecting the cable, check this protrusion to make sure of the
inserting direction of the connector, and then push the connector as far as it will go.
• Push each connector as far as it will go.
The connector may cause the system to malfunction, if it is not inserted
properly.
• To disconnect the cable, always pull the connector not the cable.
Pulling the cable may cause system failure.
• Since this product uses light for communication, be careful not to dirty the ends of
its cable.
• Do not put any heavy objects on top of the cable, or bend it by force.
Doing so may cause failure or malfunction.