Filter
Top Products
4 Installing Drivers and Utilities 53
E
4
Installing Drivers and Utilities
This chapter explains the procedure for installing drivers and utilities.
• For installing drivers and utility (HBAnyware) at the same time.
"4.1 Automatic Installation"(pg.53)
• For installing drivers and utility (HBAnyware) manually.
"4.2 Manual Installation"(pg.55)
4.1 Automatic Installation
The following shows the procedures for installing drivers and HBAnyware, using "AutoPilot
Installer" that enables automatic installation.
If [Welcome to the Found New Hardware Wizard] appears during startup, click [Cancel].
1 Insert the driver disk (CD-ROM) into the CD-ROM drive.
2 Execute "EMCStorportMiniportKit_1-30a9-1b.exe" in the driver
disk.
3 Click [Next].
4 Click [Install].
When the "EMC Storport Miniport Driver Kit 1.30a9-1b" window appears, click [OK].
5 Confirm that "Start AutoPilot Installer" is checked, and then click
[Finish].
"AutoPilot Installer" starts.
6 Click [Next].
When the "Autopilot Installer Warning" window appears, click [Yes] or [OK] (This
window may appear multiple times).
Installation process starts.
When the "Monitoring the Installation" window appears, click [Next].
When the "Welcome to the Found New Hardware Wizard" window appears, install as follows
(this window may appear after restart).
When installing drivers, logon using administrator privileges.