Filter
Top Products
E-11
EnglishDeutschEspañolFrançaisItalianoPortuguês
ġུġࢊ
Póññêèé
Ё᭛
• Use the three adjusters on the bottom of the projector (one on the front end and two on the rear) to adjust the projection position.
• Unless the projector and projector screen are aligned properly, distorted picture will result.
• When you make this equipment to project by putting on a desk etc., a small vibration might transfer to the desk etc. Please attach 2
antivibration cushions to 2 rear adjuster for reducing the vibration transfer.
ADJUSTMENT OF PROJECTION POSITION
1
Lift the front portion of the projector, and
turn the adjuster on the bottom to adjust
its height.
The length of the adjuster extends as it is turned.
2
If the picture is tilted rightward or
leftward against the projector screen,
turn either of the two adjusters at the rear
portion of the projector to adjust the
picture position.
The length of the adjuster extends as it is turned.
Warning
• Place the projector at least 20 cm away from the wall. Do not install it at ill-ventilated places. Otherwise, there is the risk of fire.
• Do not install the projector on a carpet or bedding.
Do not block the ventilation openings. Otherwise, a fire will be caused.
• To suspend the projector from the ceiling, request ask your dealer for help. Do not use mounting fittings other than specified by the manufacturer.
Otherwise, risk of the projector falling from the ceiling, personal injury, fire and electric shock will result.
• Use the receptacle near the projector unit that allows easy connection and disconnection of the projector's power plug. When installing the
projector to a place on a permanent basis such as ceiling mount, request a professional electrician to attach a circuit breaker. While the projector
is out of use, be sure to turn off the main power source using the circuit breaker or the like.
• If you find anything unusual about the projector unit, pull out the power plug from the receptacle, or turn off the circuit breaker immediately. If
the projector left as it is, a fire or an electric shock may result.
• When the front of the projector is raised by using the adjuster, do not put your hand on one side of the projector.
It will lurch to cause personal injury or malfunction.
ATTACHMENT OF ANTIVIBRATION CUSHION
PROJECTOR SECTION-REAR
Attached position of antivibration cushions.
Note
The display is a highly precise piece of equipment and therefore must be packed properly before transportation. Be sure to use only those packing
materials originally supplied with the display when repacking it.
Reference
See P. E-59 for more information on options.