Filter
Top Products
E-30
BASIC OPERATIONS (Continued)
TURNING THE POWER TO STANDBY
1
Press .
The confirmation display appears.
2
Press E to select "OFF".
3
Press <.
The projector operates as follows:
(1)The color of the power indicator lamp turns from
green to orange (flashing) to indicate that the
cooling of the light source lamp is in progress.
(2)The cooling fan rotates for 2 minutes. For one
minute after the cooling of the light source lamp
is started, the buttons on the projector and
remote control are disabled, and the light source
lamp cannot be lighted again. (After one
minute, the lamp can be turned on again.)
(3)When the cooling is completed, the fan stops
operation, and then the power monitor indicator
lamp turns on in red, resulting in the "standby"
mode.
* Even after the power is turned to standby mode,
the cooling fan continues rotating while high
temperature remains inside the projector (for
approximately 2 minutes). While the cooling is in
process, do not unplug the power cord from the
receptacle.
* Pressing "POWER" button twice successively
will also turn the power to standby mode.
* You can also use the buttons on
the projector's control panel to
perform these steps.