Filter
Top Products
E-51
EnglishDeutschEspañolFrançaisItalianoPortuguês
ġུġࢊ
Póññêèé
Ё᭛
• Setting RGB Input Signal Compulsorily (Direct Setting) for RGB
You can use this option to switch the setting for RGB input signal.
Each time you press
E or F, one of the available choices appears in the following sequence:
[Auto]: The optimum display is obtained automatically for input signals.
[Others]: The optimum resolution setting is fixed for each signal.
Press
< to store.
* In Auto mode, the resolution of VGA, WVGA, 480P, XGA, WXGA, SXGA and SXGA
+
may not be
automatically distinguished. Switch to the fixed display when the image is not displayed properly.
* Signals that are not applicable depending on the model or input terminals may not be displayed.
• Specifying RGB Input Signal (Code Setting) for mD-sub input
Normally, use this option in Auto mode.
• Changing background color to blue (Blank Screen)
When no picture signal is input, the background color can be changed to blue.
Each time
E or F is pressed, the background color changes over.
Press
< to store.
• Setting Exhibition Mode (Exhibition Mode)
You can use this option to display the enhanced contrast, to demonstrate the projector's bright, high
contrast picture.
Each time you press
E or F, one of the available choices appears in the following sequence:
On < Off
Press
< to store.
* In Exhibition mode, the display returns to the original setting in about 5 minutes even if the adjustment is changed.
* The setup will be cancelled when removing the power plug from the receptacle.
Black Blue
Note
• The screen display disappears if there is no operation within approximately 60 seconds.
• Depending on the model or the optional devices, some of the functions may not be available.
• The adjustment range varies according to the display signals. Make adjustments to your preferred Sharpness within the adjustment range.
• Depending on the type of signal, it may not be possible to make some of the settings or adjustments.