Filter
Top Products
10 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1060 • November 2007
SPARC Enterprise
M4000/M5000 Servers
Service Manual
4-11 4.4.3, "Powering the Server Off Manually" Step 4
"Verify the state of the status XSCF STANDBY LED on the
operator panel is off" should be replaced with the following
description: "Verify the state of the status Power LED on the
operator panel is off."
SPARC Enterprise
M4000/M5000 Servers
Service Manual
8-5 8.1.2, "Removing the PCI Cassette"
The cable management arm of the SPARC Enterprise M4000
server will not be supported. The following note will be deleted
accordingly.
Note - The cable management arm of the SPARC Enterprise
M4000 server might obstruct access to the PCI cassettes. Do not
force the arm out of the way of the cassettes, because it will
become permanently bent. Pull the quick release button and
disconnect the slide end of the arm. Once disconnected, the arm
can be safely held out of the way when removing the cassettes.
Instead, the following caution will be added.
Caution – When removing cables such
as LAN cable, if your finger can't reach
the latch lock of the connector, press the
latch with a flathead screwdriver to
remove the cable. Forcing your finger
into the clearance can cause damage to
the PCI card.
SPARC Enterprise
M4000/M5000 Servers
Service Manual
8-6 8.1.3, "Installing the PCI Cassette"
See “Installing the PCI Cassette” on page 13 for the changes.
SPARC Enterprise
M4000/M5000 Servers
Service Manual
"Cold Replacement"
"This step includes turning the keyswitch to the Service
position, verifying the state of the LEDs and disconnecting
power cables" should be substituted with the following
description: "This step includes turning the keyswitch to the
Service position, verifying that the Power LED is turned off and
disconnecting power cables."
TABLE 2 Documentation Updates (Continued)
Title Page Number Update