Filter
Top Products
26 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1060 • November 2007
6539909 Do not use the following I/O cards for
network access when you are using the boot
net install command to install the Solaris
OS:
• X4447A-Z/X4447A-Z, PCIe Quad-port
Gigabit Ethernet Adapter UTP
• X1027A-Z/X1027A-Z, PCIe Dual 10 Gigabit
Ethernet Fiber XFP
When running Solaris 10 11/06, use an
alternate type of network card or onboard
network device to install the Solaris OS via the
network.
6542632 Memory leak in PCIe module if driver attach
fails.
There is no workaround.
This bug has been fixed in Solaris 10 8/07.
6545143 When kcage daemon is expanding the kcage
area, if the user stack exists in the expanded
area, its area is demapped and might cause a
ptl_1 panic during the flushw handler
execution.
There is no workaround. Check for the
availability of a patch for this defect.
6545685 If the following message displayed on the OS
console, memory degradation or XSB
deconfiguration may occur in the subsequent
reboot.
Example:
mc-opl: WARNING: mc-opl rewrite timeout on
/LSB0/B0
Add the following to /etc/system and then
reboot the domain:
set mc-opl: mc_max_rewrite_loop =
20000
6546188 The system panics when running hotplug
(cfgadm(1M)) and DR operations
(addboard(8) and deleteboard(8)) on the
following cards:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
There is no workaround.
For Solaris 10 8/07, check for the patch 127741-
01 for this defect.
For Solaris 10 11/06, check for the patch
125670-04 for this defect.
Note: See CR ID 6608404 regarding issues with
hot-plug of these cards in slot 1.
6551356 The system panics when running hotplug
(cfgadm(1M)) to configure a previously
unconfigured card. The message "WARNING:
PCI Expansion ROM is not accessible" will be
seen on the console shortly before the system
panic. The following cards are affected by this
defect:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
Perform cfgadm -c disconnect to
completely remove the card. After waiting at
least 10 seconds, the card may be configured
back into the domain using the cfgadm -c
configure command.
Check for the patch 127741-01 for this defect.
TABLE 7 Specific Issues and Workarounds Concerning Solaris (Continued)
CR ID Description Workaround