Filter
Top Products
20 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1060 • November 2007
6466617 Performing a hot plug operation with the PCI-
Express slot too quickly interrupts a PCI leaf
reset and fails, creating a cfgadm: Component
system is busy error.
Pause a few seconds between the issue of each
cfgadm -c command.
6472153 If you create a Solaris Flash archive on a non-
SPARC Enterprise M4000/M5000 sun4u server
and install it on a SPARC Enterprise
M4000/M5000 sun4u server, the console's TTY
flags will not be set correctly. This can cause
the console to lose characters during stress.
Just after installing Solaris OS from a Solaris
Flash archive, telnet into the SPARC Enterprise
M4000/M5000 server to reset the console's
TTY flags a follows:
# sttydefs -r console
# sttydefs -a console -i "9600 hupcl
opost onlcr crtscts" -f "9600"
This procedure is required only once.
6481002 Installing the Solaris from the network using
certain PCI-Express cards may cause a panic.
If you are using a Sun PCI-E Dual Gigabit
Ethernet Adapter MMF card or a Sun PCI-E
Dual Gigabit Ethernet Adapter UTP card, do
not install the Solaris using either of these
cards. Instead, use other network devices, such
as the onboard Gigabit Ethernet or another
network device.
6485555 On the SPARC Enterprise M4000/M5000
servers, On-board Gigabit Ethernet NVRAM
corruption could occur due to a race condition.
The window of opportunity for this race
condition is very small.
None available at this time.
This bug has been fixed in Solaris 10 8/07.
6495303 The use of a PCIe Dual-Port Ultra320 SCSI
controller card (SG-(X)PCIE2SCSIU320Z) in
IOU Slot 1 on a SPARC Enterprise
M4000/M5000 server may result in a system
panic.
Do not use this card in IOU Slot 1 on a SPARC
Enterprise M4000/M5000 server.
This bug has been fixed in Solaris 10 8/07.
TABLE 7 Specific Issues and Workarounds Concerning Solaris (Continued)
CR ID Description Workaround