Filter
Top Products
SPARC Enterprise M4000/M5000 Servers Product Notes 17
RTIF1-
070914-019
The CLI 'showldap -c' (which displays
current LDAP certificates) will show proper
data only when used with the same user
account that had originally provided certificate
information using 'setldap -c'. Any other
user account will generate "Permission denied"
error. Similarly, the XSCF Web’s LDAP
Configuration pop-up screen will display no
data, when a different user account is used.
Use the same user account for all LDAP
display or configuration operations, for both
CLI and XSCF Web.
RTIF1-
070914-020
On the User Account setting page on the User
Manager screen, after the password change
resulted in "Change Password Error," when
you click on the REFRESH button, there
appears the error message "No user. The
request is aborted."
To change the password, select User Manager
on the Menu again.
RTIF1-
070914-021
During the Open BootPROM process, when
you power off the domain, the error log of
Domain hang-up detected (level3) may be
registered.
This error log can be safely ignored.
RTIF1-
070914-023
When you specify the domain ID or XSB
number which are not supported on the
machine, there appears the parameter error
message.
To specify the available domain ID or XSB
number on the machine.
RTIF1-
071102-001
The XSCF firmware monitors itself and if it
detects any inconsistencies, it forces an XSCF
reboot.
There is no workaround. Allow the XSCF Unit
to finish rebooting. It returns to normal
operation within approximately 5 minutes.
RTIF1-
071102-002
The snmp daemon might quit. To restart the snmp daemon, issue the
command setsnmp enable.
RTIF1-
071116-001
After using the addfru(8) or replacefru(8)
command to hotplug a CMU, further DR
operations might fail with a misleading
message regarding the board being
unavailable for DR.
When performing the addfru(8) and
replacefru(8) commands, it is mandatory to
run diagnostic tests. If you forget to run the
diagnostic tests during
addfru(8)/replacefru(8) then either run
testsb(8) to test the CMU or remove the
CMU/IOU with the deletefru(8) command
and then use the addfru(8) command with the
diagnostic tests.
RTIF1-
071116-003
Using the XSCF Web, when you selected COD,
codusage details cannot be displayed correctly.
Use showcodusage(8) command to display
the codusage.
TABLE 6 XCP Issues and Workarounds (Continued)
ID Description Workaround