Filter
Top Products
SPARC Enterprise M4000/M5000 Servers Product Notes 31
Upgrading From XCP104x to XCP 1050 or Later The
following steps describe the case of upgrading to XCP1060.
Note – LAN connections are disconnected when the XSCF resets. It is recommended
to use the XSCF serial connection to simplify the XCP upgrade procedure.
1. Log in to the XSCFU on an account with platform administrative privileges.
2. Verify that there are no faulted or deconfigured components by using the
showstatus(8) command.
The showstatus(8) prompt will return if there are no failures found in the System
Initialization. If anything is listed, contact your authorized maintenance
representative before proceeding.
Note – Take information with using BUI or snapshot(8) command. This will be
help in case any problem occurred in this procedure.
3. Power off all domains.
4. Confirm that all domains are stopped:
5. Move the key position on the operator panel from Locked to Service.
6. Collect an XSCF snapshot to archive system status prior to upgrade.
7. The BUI can be used to upload the XCP 1060 upgrade image.
XSCF> showstatus
XSCF> poweroff -a
XSCF> showlogs power
XSCF> snapshot -t user@host:directory