Filter
Top Products
24 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1060 • November 2007
6522433 After the CPU hardware error occurred, the
fmdump(1M) command on the domain may
display an incorrect faulty component.
Check system status on XSCF.
6527811 The showhardconf(8) on XSCF can not
display PCI card information that is installed
in External I/O Expansion Unit, if the External
I/O Expansion Unit is configured using PCI
hotplug.
There is no workaround. When each PCI card
in the External I/O Expansion Unit is
configured using PCI hotplug, the PCI card
information is displayed correctly.
6530178 DR addboard(8) command can hang. Once
problem is observed, further DR operations are
blocked. Recovery requires reboot of the
domain.
There is no workaround.
This bug has been fixed in Solaris 10 8/07.
6529714 Warning messages occur while trying to
configure more than four X4447A-Z or
X1027A-Z1 cards into one I/O Boat.
No workaround available at this time.
6530288 Ap_Id format may not be shown correctly by
cfgadm(1M) command.
None available at this time.
This bug has been fixed in Solaris 10 8/07.
6530753 Some of the PCI slots in the External I/O
Expansion Unit PCI slots are not displayed
during a normal boot operation.
Use one of the following operations to display
all of the PCI slots.
• boot -r (at open boot prompt)
• devfsadm -C (at Solaris prompt)
• cfgadm (twice at Solaris prompt)
6531036 The error message network
initialization failed can appear
repeatedly after boot net installation.
There is no workaround.
6531668 System hangs when executing parallel hot
plug operation with SP DR in suspend phase.
No workaround available at this time.
6532215 volfs or dscp service may fail when domain is
booted.
svc:/platform/sun4u/dscp:default:
Method "/lib/svc/method/svc-dscp
start" failed with exit status 95.
svc:/system/filesystem/volfs:defaul
t: Method or service exit timed
out. Killing contract 59.
Restart the service if the failure is observed. To
avoid the problem, issue the following
commands.
# svccfg -s dscp setprop
start/timeout_seconds=count: 300
# svccfg -s volfs setprop
start/timeout_seconds=count: 300
# svcadm refresh dscp
# svcadm refresh volfs
TABLE 7 Specific Issues and Workarounds Concerning Solaris (Continued)
CR ID Description Workaround