Filter
Top Products
SPARC Enterprise M4000/M5000 Servers Product Notes 27
6556742 The system panics when DiskSuite can not
read the metadb during DR. This bug affects
the following cards:
• SG-XPCIE2FC-QF4, 4Gb PCI-e Dual-Port
Fibre Channel HBA
• SG-XPCIE1FC-QF4, 4Gb PCI-e Single-Port
Fibre Channel HBA
• SG-XPCI2FC-QF4, 4Gb PCI-X Dual-Port
Fibre Channel HBA
• SG-XPCI1FC-QF4, 4Gb PCI-X Single-Port
Fibre Channel HBA
Panic can be avoided when a duplicated copy
of the metadb is accessible via another Host
Bus Adaptor.
Check for the patch 125166-06 for this detect.
6559504 Messages of the form nxge: NOTICE:
nxge_ipp_eccue_valid_check: rd_ptr = nnn
wr_ptr = nnn will be observed on the console
with the following cards:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
These messages can be safely ignored.
For Solaris 10 8/07, check for the patch 127741-
01 for this defect.
6563785 Hot-plug operation with the following cards
might fail if a card is disconnected and then
immediately reconnected:
• SG-XPCIE2SCSIU320Z Sun StorageTek PCI-
E Dual-Port Ultra320 SCSI HBA
• SGXPCI2SCSILM320-Z Sun StorageTek PCI
Dual-Port Ultra320 SCSI HBA
After disconnecting a card, wait for a few
seconds before re-connecting.
Check for the patch 127750-01 for this detect.
6564332 Hot-plug operations on Sun Crypto
Accelerator (SCA)6000 cards can cause SPARC
Enterprise M8000/M9000 servers to panic or
hang.
Version 1.0 of the SCA6000 driver does not
support hot-plug and should not be attempted.
Version 1.1 of the SCA6000 driver and
firmware supports hot-plug operations after
the required bootstrap firmware upgrade has
been performed.
Note: See CR ID 6619344 for issues with
hotplug of Sun Crypto Accelerator (SCA) 6000
cards in slot-1.
6564934 Performing a DR deleteboard(8) operation
on a board which includes Permanent Memory
when using the following network cards
results in broken connections:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
Re-configure the affected network interfaces
after the completion of the DR operation. For
basic network configuration procedures, refer
to the ifconfig man page for more
information.
Check for the patch 127741-01 for this detect.
TABLE 7 Specific Issues and Workarounds Concerning Solaris (Continued)
CR ID Description Workaround