Filter
Top Products
4.5 ATA Commands
C156-E205-01EN 4-37
4.5.11 SLEEP (E6h)
Table 4.36 SLEEP command
Bit
76543210
CM11100110
DHXXXDEVXXXX
CHXXXXXXXX
CLXXXXXXXX
SNXXXXXXXX
SCXXXXXXXX
FRXXXXXXXX
The SLEEP command sets the ODD in sleep mode. The ODD enters sleep mode
by following the steps given below.
1. The ODD spins down media.
2. The ODD issues an interrupt to the host to report command end. After the
host receives the interrupt, the ODD deactivates the interface. Once the
interface becomes inactive, the ODD ignores all resets except software reset
and hardware reset and Device Reset command.
A software reset, or hardware reset or Device Reset command is required for a
return from sleep mode.
Software reset is recommended for returning from sleep mode.