Filter
Top Products
C156-E205-01EN 3-1
CHAPTER 3 Installation Requirements
This chapter describes environmental, mounting, power supply, and connection
requirements.
3.1 Environmental Requirements
The environment in which these drives are installed must comply with the ambient
environmental requirements defined in Subsection 2.1.3.
3.1.1 Temperature measurement point
When a drive is operating, the ambient temperature measured 3 cm from the base
surface of the optical disk drive and the PCA unit surface must satisfy the
environmental requirements specified in Subsection 2.1.3. For the temperature of
each surface during operation, the contact temperature at each measurement point
shown in Figure 3.1 must satisfy the requirements specified in Subsection 3.1.2.
Low temperature burns:
The surface temperatures of some ICs
on the printed circuit board unit in the optical disk drive exceed
55°C while operating. Be careful of low tenperature burns.
3.1 Environmental Requirements
3.2 Mounting Requirements
3.3 Power supply Requirements
3.4 Cable Connections
3.5 Jumper Settings
3.6 Notes on Drive Handling
3.7 Mounting
3.8 Cable Connections
3.9 Operation Confirmation and Preparation for Use after Installation
3.10 Dismounting Drive