Filter
Top Products
38 SPARC Enterprise T5140 and T5240 Servers Administration Guide • July 2009
▼ Reconfigure a Device Manually
The ILOM firmware provides a set Device-Identifier component_state=enabled
command, which enables you to reconfigure system devices manually. Use this
command to mark the specified device as enabled.
1. “Log In to ILOM” on page 2.
2. At the ILOM -> prompt, type:
Related Information
■ “Devices and Device Identifiers” on page 38
■ “Unconfigure a Device Manually” on page 37
Devices and Device Identifiers
The device identifiers are case-sensitive.
-> set Device-Identifier component_state=enabled
Device Identifiers Devices
/SYS/MB/CMPcpu_number/Pstrand_number CMP (0-1) CPU strand (0-63)
/SYS/MB/CMPn/RISERn/PCIEslot_number CMP (0-1) Riser (0-1) PCIe slot
(0-5)
/SYS/MB/CMPn/RISERn/XAUIcard_number CMP (0-1) Riser (0-1) XAUI
card (0-1)
/SYS/MB/NETnetwork_number Network interfaces (0-3)
/SYS/MB/PCIE PCIe root complex
/SYS/MB/USBnumber USB ports (0-1, located on rear
of chassis)
/SYS/MB/CMPn/L2_BANKnumber CMP (0-1) Bank (0-7)
/SYS/DVD DVD