Filter
Top Products
17
Basic Operation
Make sure the projector is set up as described on page 11, then follow the instructions below
to turn it on and display an image.
Turning On the Projector
1. Remove the lens cap.
2. Press the
On button on the remote control or press the
Power button on the projector.
The projector takes about 30 seconds to warm up and
display an image. If you don’t see a picture, you may
need to change the image source as described on the
next page.
Note: If this is your first time using the remote control,
make sure batteries are installed as described on page 50.
To keep children from turning on the projector, you can use
the projector’s Child Lock (see page 24).
Turn on the projector
PowerLite Cinema 200+.book Page 17 Thursday, August 18, 2005 2:37 PM