Filter
Top Products
Magnum 3000 Stackable Hubs Installation and User Guide (07/06)
39
www GarrettCom com
..
Table 5.3: Eight-Position DIP Switch Configuration Table
address
\
switch 123456
1 on
2 on
3 on on
4 on
5 on on
6 on on
7 on on on
8 on
9 on on
10 on on
11 on on on
12 on on
13 on on on
14 on on on
15 on on on on
16 on
17 on on
18 on on
19 on on on
20 on on
- The Group # Address is used by the network manager to distinguish among the
physical units that are combined (or grouped) in the stack to operate as one repeater
managed by one SNMP agent. The NMS display will show the stack units arranged in
sequence according to the Group #. (The SNMP standard defines the term "Group #" for
data collection and control operations.)
It is desirable to use Group Address # 1 for the Magnum 3024 or 3012 unit
which houses the embedded agent.
- Switch # 7 and Switch # 8 are not used.
See also Section 2.3.3, Address Switch Settings, for further information on this topic.
5.4 Agent Configuration, Embedded Agent and Agent Box Versions
The SNMP Agent software resides in ROM chips on the hardware agent board.
After power up, the software begins a number of tests that check the system for normal