Filter
Top Products
Magnum 3000 Stackable Hubs Installation and User Guide (07/06)
42
www GarrettCom com
..
3. COMMUNITY
C[OMMUNITY] [# [NAME [S] [MANAGER....]]]
Used to set the community string for GET and SET operations.
# -- number of community. (Up to 10 different communities may be set)
S -- allow SET operations. (If you do not "S" this command, this community will allow
only GET operations)
MANAGER -- the network manager IP addresses list, up to 10. (If the manager IP
addresses list is not present in a command line, any network manager can
communicate with this agent using this community string)
Example of two managers: >C 3 MAGNUM S 45.9.0.122 45.9.1.3{Cr}
To display community, type: C{Cr}
To delete community, type: C [#] {Cr}
3. DISPLAY
To display the whole configuration file, type: D{Cr}
Example: >D{Cr} ( All configuration information will appear )
4. EXIT
To exit from the configuration menu, type E{Cr}
Example: >E{Cr}
5. GATEWAY
G[ATEWAY] [# [IP [SUBNETIP [MASKIP]]]]{Cr}
Used to set the gateway IP address and mask. Up to 10 gateways may be set.
Example: >G 3 45.9.0.112 255.255.255.0 255.0.0.0{Cr}
6. MANAGER
M[ANAGER] [# [IP/NAME [PORT] COMMUNITY]]]
Used to set the number of network manager IP addresses, and the community to which
TRAPS should be sent. Up to 10 managers may be set. If "PORT" is absent, then
TRAPS are sent to port 162, as specified in RFC 1157. If "COMMUNITY" is absent, the
community string "public" is used by default.
Example: M 2 45.9.1.125 Magnum{Cr}
7. SUBNETMASK
S[UBNETMASK] [IP]{Cr}
To set IP mask, type: S [ mask value] {Cr}
Example: >S 255.255.255.0 {Cr}
NOTE: After entering information using the commands above, to make the new configuration
operative, exit from the configuration menu by typing: E {Cr}. If the agent's IP address has
been changed, reset the agent (via a unit power down) to install the change.