Filter
Top Products
51
Installing drives
www.gateway.com
16 If you removed the front cover, replace it.
17 Close the server case by following the instructions in “Closing the server
case” on page 44.
Installing a hard drive
To install a hard drive:
1 Follow the instructions in “Preventing static electricity discharge” on
page 41.
2 Open the server case by following the instructions in “Opening the server
case” on page 42.
3 If you are replacing a hard drive, disconnect the old drive’s cables.
4 Slide the drive release latch toward the open side of the case.
Important Drives connected to the primary and secondary IDE
connectors should be ATA100 drives, and drives
connected to the third IDE connector should be ATA66
drives.