Filter
Top Products
81
Error messages
www.gateway.com
Error messages
These messages often indicate procedural errors such as typing an incorrect
keystroke or trying to save a file to a write-protected diskette. Some messages,
however, may indicate a problem that requires further troubleshooting.
Access denied
■ Your diskette is write-protected. Move the write-protection tab over the
window on the back of the diskette, or save to a new diskette.
Bad command or file name
■ Make sure that you entered the right command.
■ Make sure that the specified drive is correct, then try again.
■ If you are trying to exit MS-DOS to return to Windows, type exit, then
press E
NTER.
Base memory [xxx] expansion
■ This is an informational message only. No action is required.
CD drive is not recognized
■ See “Your server does not recognize a CD or the CD drive” on page 88 for
a possible solution.
Data error
■ In Windows 2000 Server, run CheckDisk on the drive with the error.
Diskette drive 0 seek to track 0 failed
■ Open the BIOS Setup utility, then make sure that the drive settings are
correct.
■ Check the diskette drive cables. Make sure that Pin 1 on the cable aligns
with Pin 1 on the connector.
Diskette drive reset failed
■ Open the BIOS Setup utility, then make sure that the drive settings are
correct.
■ Check the diskette drive cables. Make sure that Pin 1 on the cable aligns
with Pin 1 on the connector.