Gateway 920 Server User Manual


 
82
Chapter 6: Troubleshooting
www.gateway.com
Diskette read failed - press F1 to retry boot
Make sure that the startup diskette contains the command.com file.
Open the BIOS Setup utility, then make sure that your drive or controller
is configured correctly.
Press F1 to restart the server.
Make sure that the diskette drive cable is connected securely.
Error loading operating system
The master boot record may be corrupt. For troubleshooting information,
see “The master boot record is corrupted” on page 92.
Hard disk controller failure
Make sure that the hard drive cable is connected securely.
Open the BIOS Setup utility, then make sure that the correct drive type is
selected.
Hard disk controller failure - press F1 to try reboot
The drive controller may be defective. Press F1 to try to restart the server.
Try running FDISK and DOS Format to check the integrity of the hard drive.
For more information, see your operating system’s documentation.
See “You need to troubleshoot an IDE hard drive” on page 93.
Insert bootable media device
Make sure that the correct hard drive is set as the first bootable drive in
the Boot menu of the BIOS Setup utility.
See “Your server does not recognize an IDE drive” on page 92 or “Your
server does not recognize a SCSI drive” on page 92 for a possible solution.
Insufficient disk space
Check the free space on the drive. If the drive is almost full, remove
unnecessary files. For more information, see “Using Disk Cleanup” on
page 24.
Invalid configuration information
Open the BIOS Setup utility, then make sure that the settings are correct.
See “Resetting the BIOS” on page 75 for a possible solution.