Filter
Top Products
Page 4-1
640t – Installation and Operating Instructions
This chapter describes how to install the machine.
There are no operator serviceable parts to the
machine other than periodic cleaning. Refer to
“7. Operator Maintenance” on page 7-1.
WARNING: Do not attempt to service or repair
the laminator. Failure to observe this warning could
result in severe personal injury or death.
Disconnect the plug from the receptacle and contact
your dealer or distributor when one or more of the
following has occurred.
The power supply cord or attachment plug is •
damaged.
Liquid has been spilled into the laminator.•
The laminator is malfunctioning after being •
mishandled.
The laminator does not operate as described •
in these instructions.
pr i o r t o in s t a l l a t i o n
Inspect the package for damage. Shipping damage
should be brought to the immediate attention of the
delivering carrier.
in s t a l l a t i o n
To set up the laminator for the first time:
Place the laminator on a stable flat surface 1.
capable of supporting the weight of the machine.
An additional work surface near the laminator is
recommended for items to be laminated.
The laminator should be located so that when 2.
not using the rear rewind, exiting film drops freely
to the floor or to a table that is lower than the exit
point of the laminator. Accumulation of laminate
immediately behind the laminator as it exits the
equipment may cause the film to wrap around
the rollers, jamming the machine.
Avoid locating the laminator near sources of heat 3.
or cold. The laminator should not be in the direct
path of forced heated or cooled air.
Connect the attachment plug provided with the 4.
laminator to a suitably grounded outlet only.
4. in s t a l l a t i o n