Filter
Top Products
Page 7-1
640t – Installation and Operating Instructions
ca r i n g f o r t h e 640t la m i n a t o r
The only maintenance required by the operator
is to periodically clean the rollers. The following
procedure will help keep the rollers free of dirt and
adhesive, which has been deposited along the edge
of the laminating lm. Proper alignment of the rolls of
lm reduces the amount of adhesive on the rollers.
Perform only the routine maintenance procedures
referred to in these instructions.
WARNINGS:
Do not attempt to service or repair the laminator. •
Do not apply any cleaning uids or solvents to the •
rollers. Some solvents and uids could damage
the rollers.
Keep ngers and hands away from the rollers •
when the machine is running. They could be
trapped and crushed in the rollers. Clothing,
jewelry, and long hair could be caught in the
rollers and pull you in.
Failure to observe these warnings could result in
severe personal injury or death or damage the
machine.
cl e a n i n g th e ro l l e r s
Keeping the rollers clean ensures that your nished
items will not be damaged by dirt and adhesives.
Clean the rollers with a clean, damp lint-free cloth.
If there are any adhesive build ups, you may use
isopropyl alcohol instead of water.
Never clean rollers with abrasive, sharp, or •
pointed objects.
Do not use any other cleaning agents other •
than those listed above.
Accumulated adhesive deposits on the rollers •
can cause damage to the rollers. Rotate the
rollers at the lowest speed setting on the
control panel.
To clean the rollers and idler bar:
Remove the print clamp and feed table. Refer 1.
to “Removing and Installing the Print Clamp” on
page 6-3 and “Removing and Installing the Feed
Table” on page 6-3.
Remove the film from the laminator. Refer to2.
“Loading Film Onto the Supply Shafts” on page 6-4
Use the dampened cloth to remove any dust, 3.
dirt, and other foreign materials from the rollers.
Press and release the 4. foot switch to rotate the
rollers to an unclean portion.
Keep your hands, fingers, pad, and rag away
while running the machine. Be sure to remove all
adhesive and dirt.
Install the feed table and print clamp.5.
7. op e r a t o r ma i n t e n a n c e