Filter
Top Products
Chapter 1— Getting Started Cd 39 Helvetica CondensedHelvetica
6 EasyCoder 3400e Bar Code Label Printer User’s Manual
1 2 3 4 5 6 7 81 2 3 4 5 6 7 8
O
I
3XXXU.006
Media access
slot
Fanfold
media
➤
➤
➤
➤
➤
Lower
media guide
Head lift
lever
Supply
roll
post
Edge
guide
Supply
roll
retainer
5 To allow easy access to the media path, pull down on the lower media
guide. Make sure that the edge guide is slid all the way to the outer edge
of the edge guide plate.
6 Insert the fanfold media through the printer mechanism as shown in the
next illustration. The front edge of the media should pass over the tear
bar and through the label dispense opening in the media cover. The
fanfold media should pass over the supply roll post.
7 Release the lower media guide and adjust the edge guide to position the
media firmly against the inside wall of the printer.
8 Slide the supply roll retainer up to the edge of the fanfold media and
turn the supply roll retainer clockwise until it locks firmly in place
securing the media against the inside wall of the printer.
9 Engage the printhead by rotating the head lift lever counterclockwise
until it locks.
10 Close the printer by reversing the directions for removing the cover.
11 Press Feed/Pause to advance one label through the printer and out the
label opening in the front cover. The printer is now ready to print the
configuration test label. The yellow Empty/Pause LED goes out.
If the yellow Empty/Pause LED does not go out, press Feed/Pause a
second time and then reload the media and try again if the Empty/Pause
LED still does not go out.