Filter
Top Products
139
Section 11 Certification
The manufacturer certifies this instrument was tested thoroughly, inspected and found to
meet its published specifications when it was shipped from the factory.
Canadian Interference-causing Equipment Regulation, IECS-003, Class A
Supporting test records by ETS Product Service AG, Storkower Str. 38c, 15526
Reichenwalde and certified compliance by the manufacturer.
This Class A digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
GSM modem MC56 is listed under IC: 267W-MC56.
FCC PART 15, Class “A” Limits
Supporting test records by ETS Product Service AG German Test Center and certified
compliance by the manufacturer.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense. The following techniques of
reducing the interference problems are applied easily.
1. Disconnect the sc1000 probe and display modules from the power source to verify
that it is or is not the source of the interference.
2. If the sc1000 probe and display modules are connected into the same outlet as the
device with which it is interfering, try another outlet.
3. Move the probe and display modules away from the device receiving the
interference.
4. Position the receiving antenna for the device receiving the interference.
5. Try combinations of the above.
GSM modem MC56 is listed under FCC identifier QIPMC56.
Note: GSM modem antennas must not exceed 7dBi gain (GSM1900) and 1.4dBi gain (GSM 850) for
mobile and fixed operating configurations.
Profibus
Certified Profibus DP/V1 slave device, Physical layer RS485. Certificate No Z01238.