24
Figure 6: Adjusting the Feeder angle
If the Feeder looks to be hanging evenly on both the le and right
sides, then you are done. Skip the rest of this procedure.
If the angle looks like it requires adjustment, then use the soware-
assisted procedure to unmount the Feeder from the scanner as de-
scribed in “Unmounting the Feeder” on page 12.
Find the adjustment tool that was supplied with your Batch Feeder. It
is a thin metal bar with notches cut at each end.
Use the adjustment tool to loosen the nuts on the opposite side of the
two adjustment bolts shown in Figure 7.
3.
4.
5.
6.