Filter
Top Products
26
Find the adjustment tool that was supplied with your Batch Feeder. It
is a thin metal bar with notches cut at each end.
Use the adjustment tool to loosen the self-locking nut on the right
side on the rear of the Feeder as indicated in Figure 8.
NOTE! Do not touch similar looking nuts to the le.
Figure 8: Unlocking/locking the Feeder position
Use the soware-assisted procedure to mount the Feeder to the scan-
ner as described in “Mounting the Feeder” on page 8. However when
you get to the last step, keep the Mount feeder window open (do not
click on Done)
2.
3.
4.