Filter
Top Products
32
Examine the bottom of the back side of the Feeder and locate the two
holes used to secure the magazine during shipping (see Figure 11,
below). Insert the shipping screws into these holes and tighten them
into place so that the magazine is secured.
Get the original box and lay down on the oor or on a table.
Open the box, remove the top slab of foam and set it aside.
Align the Feeder so that it will t into the cut foam.
Lower the Feeder into the box.
Replace the top slab and close the box.
Use packaging tape to secure the top aps of the box. We recommend
that you also wrap the box in strong shipping paper.
Figure 11: Holes for inserting the shipping screws on the back of the Feeder
If you need to return the Feeder to Hasselblad for repair, it must be
shipped in its original box. Hasselblad will not accept shipment if the
Feeder is shipped in anything other than its original box.
3.
4.
5.
6.
7.
8.
9.