Filter
Top Products
Removal and Replacement of Parts (without Calibration) 7-13
Replacement of Parts
Installing the LED PCA
Step 1. Install the new LED PCA by fitting it in from the bottom first before pushing it down till it snaps into
place. Ensure that the plastic holders secure the LED panel properly.
Step 2. Reconnect the LED PCA connector.
Caution!
Please note that the colors of the LCD connector wiring are different from that of the LED connector
wiring. When attaching both connectors, check that the sequences of the colors of the connectors
correspond on both ends.
Step 3. Reinstall the key panel by latching the four rear hinges to the chassis first.
Step 4. Snap the panel into the latches from the right side first towards the left side.
Step 5. Replace the two screws at the top of the panel.
Step 6. Reinstall the LCD cover by fitting in the hinges at the back first before pushing it down from the right
first, then the left.
Step 7. Close the top cover of the printer.
Step 8. Reinstall the output tray (Tray 1) into place.
Step 9. Reinstall the printhead access door.
Step 10. Plug in the power cord and turn on the printer.