Filter
Top Products
Removal and Replacement of Parts (without Calibration) 7-47
Replacement of Parts
Replacement of Absorbers
You will be removing the absorbers from the printer and installing new absorbers.
Removing the Absorbers
Step 1. Remove the Ink Supply Station (refer to
procedures in Removing the Ink Supply
Station from Replace of Ink Supply
Station).
Step 2. Slide the ink carriage mechanism along the
carriage rod to the left under the top cover.
This will expose three screws, previously
concealed under the ink carriage
mechanism, that secure the service station.
Step 3. Unscrew the three screws in the order
shown on the chassis.
Step 4. Remove the service station by sliding it out.
Be careful of connecting cables when
removing the service station.
Step 5. Disconnect the service station connector.