Filter
Top Products
Removal and Replacement of Parts (without Calibration)7-26
Replacement of Parts
Installing the Ink Supply Station
Step 1. Install the new ink supply station. Make sure the screws are put in first.
Step 2. Reinstall the ink delivery system by looping in the hinge on the right first, then place it down.
Step 3. Latch the wires back into the hooks and reconnect the ink supply station motor and PCB connectors.
Make sure the connectors are secured properly.
Step 4. Replace the two screws at the right side of the ink delivery system.
Step 5. Replace the remaining components for the ink supply station (refer to Steps 3-14 of Installing the
Power Knob from Replacement of Power Knob.)