Filter
Top Products
Operating Overview2-28
368 RED_DM_IO_ECP_UNSUPPORTED_CHANNEL
I/O problems –firmware problem => reset printer or PCA
replacement
Data received on unsupported channel.
369 RED_DM_IO_UNSUPPORTED_SOCKET
I/O problems –firmware problem => reset printer or PCA
replacement
371 RED_DM_MLC_CREDIT_GONE_BAD
I/O problems –firmware problem => reset printer or PCA
replacement
372 RED_DM_MLC_CREDIT_GONE_BAD2
I/O problems –firmware problem => reset printer or PCA
replacement
373 RED_DM_MLC_INSUFFICIENT_MEM
I/O problems –firmware problem => reset printer or PCA
replacement I/O problems –firmware problem => reset printer or
PCA replacement
374 RED_DM_MLC_COULDNT_ALLOC_OUTPUT
I/O problems –firmware problem => reset printer or PCA
replacement
375 RED_DM_MLC_UNKNOWN_DATA_CONTROL
I/O problems –firmware problem => reset printer or PCA
replacement
376 RED_DM_MLC_GET_INPUT_FAILED
I/O problems –firmware problem => reset printer or PCA
replacement
377 RED_DM_MLC_DEFAULT_CONFIG_FAIL
I/O problems –firmware problem => reset printer or PCA
replacement
378 RED_DM_MLC_MIDPACKET_CHANNEL
I/O problems –firmware problem => reset printer or PCA
replacement
379 RED_DM_MLC_READ_STOPPED_ERROR
I/O problems –firmware problem => reset printer or PCA
replacement
381 RED_DM_SOCKET_MULTIPLE_READS
I/O problems –firmware problem => reset printer or PCA
replacement
382 RED_DM_SOCKET_ILLEGAL_TAG
I/O problems –firmware problem => reset printer or PCA
replacement
397 RED_DM_SYS_PARAMETER_ERR Not used
398 RED_DM_INVALID_PEN Not used
399 RED_DM_NONSPEC_ERROR Not used Generic error trap (no additional information).
Mechanism Code Errors
411 MECH_BAD_MECHWARE Not supported Mechware command
412 MECH_BAD_RESOLUTION Print resolution not supported Someone asked for an unsupported resolution.
413 MECH_BAD_INIT Firmware code error – subsystem failed TaskSpawn.
414 MECH_THERMAL_SHORT Not used Pen temperature went over 95 degrees.
415 MECH_CARRIAGE_JAM
Carriage blocked – Encoder strip/ carriage motor/ carriage PCA/
Harness/ Logic PCA error
Carriage servo failure detected.
416 MECH_NO_MEMORY Firmware error or not enough memory – reset printer
417 MECH_FAIL_ADC_CAL Not used Failed the internal ADC CAL.
418 MECH_ADC_RAIL Not used The ADC was at the rails (was 423).
419 MECH_VREF_PROB Not used The ADC was probably overdriven.