Filter
Top Products
Removal and Replacement of Parts (without Calibration) 7-35
Replacement of Parts
Replacement of Assembly Harness Cover
You will be removing the assembly harness cover from the printer and installing a new assembly harness
cover.
Removing the Assembly Harness Cover
Step 1. Remove the Main Case (refer to the
procedures in Removing the Main Case
from Replacement of Main Case).
Step 2. Remove the two springs attached on both
sides of the rear door.
Step 3. Remove the back panel by pulling both the
handles and sliding it out of the printer.
Step 4. Push in the flaps of the assembly harness
cover on both the right and the left.
Step 5. The assembly harness cover pops out by
giving it a pull.