Filter
Top Products
2-14
Installing the Switch
Installation Procedures
Installing the Switch
Flat Wall Mounting
There are two switches in this series that can be wall mounted, the J9085A 24-
port Non-PoE and the J9088A 48-port Non-PoE. You can mount these switches
on a wall as shown in the illustration Figure 2-8. Wall mounting is not
supported for the 2610-PWR switches because of the size and weight of the
devices. See page 2-14 for instructions.
WARNING For safe operation do not install the switch with either side vent holes
(vertical) facing downward. Do not wall mount the 2610-PWR
switches.
Caution The switch should be mounted only to a wall or wood surface that is at least
1/2-inch (12.7 mm) plywood or its equivalent.
Supported Wall Mounting Positions.
WARNING The Switch 2610-PWR Switches are not wall mountable.
Wall mounting Horizontal
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.
2. Attach the switch to the wall or wood surface with two 5/8-inch number
12 wood screws (not included).
Switch Vertical Wall Mounting Horizontal Wall Mounting
2610 Non-PWR No Yes
2610-PWR
No No