Filter
Top Products
2-30
Installing the Switch
Sample Network Topologies for Non-PWR Switches
Installing the Switch
Because the 2610 Switches have the Auto-MDIX feature, the connections
between the switches, and between the switch and end nodes or servers can
be through category 5 straight-through or crossover twisted-pair cable.
Category 3 or 4 cable can also be used if the connection is 10 Mbps only. In all
cases, the device ports must be configured to auto negotiate the link
characteristics for this feature to work.
The switch, in turn, can be connected to a network backbone through fiber-
optic cabling connected to a Gigabit-SX, -LX, or -LH mini-GBIC. Now, all the
devices on these network segments can access other network resources that
are connected elsewhere on the network backbone. Always remember when
connecting fiber-optics that all components match in specification.
Connecting to a Backbone Switch
Figure 2-22. Networking to a gigabit ethernet backbone
To Gigabit-Ethernet
backbone
Switch 2610-48
Switch 2610-48
Gigabit
fiber-optic cables
Switch 5406zl
Switch 2610-48
Switch 2610-48