Filter
Top Products
Configuration Commands
129
Table 103 802.1x Port Configuration commands
Command Description
dot1x re-authentication-interval
{<1-604800>}
Sets the time, in seconds, the authenticator waits before re-
authenticating a supplicant (client) when periodic re-authentication
is enabled. The default value is 3600 seconds.
Command mode: Interface port
[no] dot1x re-authenticate
Sets the re-authentication status to on or off. The default value is
off.
Command mode: Interface port
default dot1x
Resets the global 802.1x parameters to their default values.
Command mode: Interface port
dot1x apply-global
Applies the global 802.1x parameters to the port.
Command mode: Interface port
show interface port {<1-16,
18-21>} dot1x
Displays current 802.1x parameters on the specified port
Command mode: All
Rapid Spanning Tree Protocol /
Multiple Spanning Tree Protocol configuration
The switch supports the IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) and IEEE 802.1s Multiple
Spanning Tree Protocol (MSTP). MSTP allows you to map many VLANs to a small number of spanning
tree groups, each with its own topology.
MSTP supports up to 32 Spanning Tree Groups on the switch (STG 32 is reserved for switch
management). MRST is turned off by default.
NOTE: When Multiple Spanning Tree is turned on, VLAN 1 is moved from Spanning Tree Group 1
to the Common Internal Spanning Tree (CIST). When Multiple Spanning Tree is turned off, VLAN 1
is moved back to Spanning Tree Group 1.
The following table describes the Multiple Spanning Tree Configuration commands.
Table 104 Multiple Spanning Tree Configuration commands
Command Description
[no] spanning-tree mstp name
{<1-32 characters>}
Configures a name for the MSTP region. All devices within a MSTP
region must have the same region name.
Command mode: Global configuration
spanning-tree mstp version
{<0-65535>}
Configures the revision level for the MSTP region. The revision level
is used as a numerical identifier for the region. All devices within a
MSTP region must have the same revision level number. The default
value is 1.
Command mode: Global configuration